Tuesday 19 May 2015

How to Replace Torsion Spring Cones



Torsion garage door springs have cones at both sides. At one side, there is a stationary cone. This cone doesn't move. It keeps the spring still on this side. On the other side, there is a winding cone. The spring moves at this side. It actually unwinds and winds in order to open and close the door. The power of the spring comes from the torque created when the spring moves on one end. The movement is transferred to the shaft, which is the metal bar passing through the spring. Since the shaft is connected to the garage door cable drums at the two sides, it transfers the spring movement to the drum which pulls the cable up. This is the way the door opens. 

So, the importance of the stationary and winding cones is great for torsion spring garage door systems. They help the spring move the right way and develop torque. Actually, the winding cone has great significance for all repairs related to torsion springs. This cone is used to unwind springs when their tension must be released and wind up springs when tension must be added. This is how garage door torsion spring adjustment is done and actually there is need to use winding bars, which are inserted in the little holes on the cone so that the spring can be adjusted or its tension released so that the spring can be removed and possibly replaced. Winding bars come out in different sizes so that they can fit in the size of each winding cone. 

Torsion spring cones replacement requires proper tools 

When you buy torsion springs, they don't necessarily have cones on them. You can buy them with or without cones. This gives you the chance to have the winding and stationary cones replaced if they are damaged or rusty regardless if you will replace the spring, too. So, the first step is to remove the torsion spring. This is one of the hardest garage door repairs since it involves high risks due to the great tension springs are under. So, if you feel uncomfortable with such tasks, trust the service of Garage Door Repair Layton. In order to remove the spring, you must unplug and disconnect the opener and keep the door closed but also steady with c-clamps over the rollers. With the help of two winding bars, unwind the torsion spring till its tension is released. Torsion springs are unwound by placing the first winding bar in the winding cone, loosening the setscrews, using the second winding bar to turn a bit the cone, placing the first winding bar to the next hole of the cone and so on until the spring is unwound and ready to be removed. 

Once the spring is removed, it must be gripped so that you can use a pipe wrench to turn the stationary cone till it comes off. You must pay attention. Once the cone is free from the spring, it will pop out and so you must stand off its way. Use the same steps in order to remove the winding cone on the opposite side of the spring. Now get the new cones and place them on the edge of the inside tube. Use one hand to push the cone and the tube inside the spring and the other hand in order to start screwing it till the end part of the cone finds the end part of the spring. Mind you that attention is needed when you are installing the new cones. For your convenience, mark which side of the spring had the stationary cone before and make sure both the stationary and winding cones are installed at the right size or you will have a problem placing them. Then you must reinstall the spring and connect all parts before you try out the door.

1 comment:

  1. I was surfing the Internet for information and came across your blog. I am impressed by the information you have on this blog. It shows how well you understand this subject. garage door replacement

    ReplyDelete